Ethernet over coax

Ethernet over Coax (EoC) is a family of technologies that supports the transmission of Ethernet frames over coaxial cable.

History

The first Ethernet standard, known as 10BASE5 in the family of IEEE 802.3, specified baseband operation over 50 ohm coaxial cable, which remained the principal medium until the 1990s when thinner, cheaper twisted pairs came to dominate the market. The use of coaxial cable for Ethernet is still supported by the standard, but rarely used because coaxial cable is more costly to purchase, install, and operate for Local Area Networks.

Research in Ethernet transmission over coaxial cable continued, as both consumers and telecommunications operators strive to use existing 75 ohm coaxial cable (from Cable Television or CATV) installations, to carry broadband data into and through the home, and into Multiple Dwelling Unit (MDU) installations.

Most EoC technologies are being developed for in home or in premise networking and are expected to be operated within the domain of a single operator.

Standards

The Institute of Electrical and Electronics Engineers (IEEE) maintains all official Ethernet standards in the 802.x family or protocols.

Active work in Ethernet over Coax is ongoing^[when?] in IEEE 1394 Trade Association (TA) developed based on the S400 standard.^{[citation needed]}

ITU-T G.hn

The ITU-T G.hn standard provides high-speed (up to 1 Gigabit/s) local area networking over existing home wires, including coaxial cable, power lines and phone lines. It defines an Application Protocol Convergence (APC) layer for encapsulation standard 802.3 Ethernet frames into G.hn MAC Service Data Units (MSDUs).

Other ITU-T standards for home networking over coaxial cable include G.9954, also known as HomePNA 3.1 .

MoCA

The Multimedia over Coax Alliance (MoCA) is an industry alliance that develops specifications for home networking over coaxial cables. The MoCA specification is technically not a standard, because MoCA is not a recognized Standard Developing Organization (SDO).

There are also proprietary EoC implementations using WiFi-like OFDM transmission.

CATV compatibility

EoC research is focused on the use of existing cable television (CATV) infrastructure for Internet access or broadband data transmission for the purpose of being compatible with the existing CATV (or sometimes satellite television) broadcast signals simultaneously transmitted on the same cable. The EoC technologies must operate outside the frequency domain currently used for CATV or for satellite receiver to set-top box transmissions. Most EoC technologies are designed to operate in frequency bands above 1 GHz, which is the upper bound of television signals and for systems designed to operate in North America using the SCTE 55-1 and SCTE 55-2 CATV transmission systems, as well as in most of Europe and portions of Asia. In many localities CATV systems operate only up to 550 MHz or 750 MHz, wherein some EoC technologies focus on using spectrum between 550 MHz or 750 MHz and 1 GHz. Though less costly, they could potentially conflict with future spectrum expansion up to 1 GHz. Some markets focus on using this 750 MHz to 1 GHz spectrum for EoC, specifically avoiding EoC bands above 1 GHz due to potential ingress noise from over-the-air transmissions and cellular systems.

See also

• DOCSIS - Data Over Cable Service Interface Specification